Will this cover my factory fog lights or sensors?

Verify your vehicle's OEM bumper opening locations before installation. If your bumper has factory cutouts for fog housings or sensors, you'll need to confirm hole alignment with this Vader 2 design and cut or route accordingly based on your setup.

What prep is needed before painting?

Sand and prep the surface thoroughly to ensure paint adhesion. The bumper Requires Surface Prep, so follow standard FRP finishing practices with your choice of primer and topcoat systems.

Does this fit with a trailer hitch?

If your vehicle has a trailer hitch receiver installed, measure the receiver position relative to the bumper overhang. The Vader 2 profile may require clearance verification before final installation to avoid contact.